00056220.DOC, Version 1.0
35/48
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the DMH-30 starts running. During the reset, the motors are
trimmed and the device is ready for use afterwards.
Stand Alone operation
In the Stand Alone mode, the DMH-30 can be used without controller.
Disconnect the DMH-30 from the controller and call the internal program.
1. Press
[MODE/ESC]
button to enter the main menu
"MODE"
(display flashing)
2. Press
[ENTER]
and select
“RUN”
by pressing
[UP]
button.
3. Press
[ENTER]
and select
“AUTO”
by pressing
[UP]
button.
4. Press
[ENTER]
and select
“ALONE”
by pressing
[UP]
button.
5. Press
[ENTER]
to confirm, the display shows
“AU-A”
.
Please refer to the instructions under Control Board, Main functions, menus Mode and Edit.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the DMH-30 will respond to the controller.
If you set, for example, the address to channel 13, the DMH-30 will use the channel 13 to 24 for control.
Please, be sure that you don’t have any overlapping channels in order to control each DMH-30 correctly and
independently from any other fixture on the DMX-chain.
If several DMH-30 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the DMH-
30 via your lighting controller.
