00123552.DOCX, Version 1.0
35/60
- - -m
Warning – risk of burns and fire
•
The admissible ambient temperature range (Ta) is -5 to +45°C. Do not operate the device outside of this
temperature range.
•
The housing temperature (Tc) can be up to 55°C during use. Avoid contact by persons and materials.
•
Do not illuminate surfaces within 20 cm of the device. This value is indicated on the device by the
symbol.
•
Do not use the device near highly flammable materials. Always place the device at a location where
sufficient air circulation is ensured. Leave 50 cm of free space around the device. Never cover the air vents
of the housing.
Warning – risk of injuries
•
Do not look directly at the light source. Persons with light-sensitive epilepsy may suffer from epileptic
seizures or fall unconscious.
•
Make sure that the product is set up or installed safely and expertly and prevented from falling down.
Comply with the standards and rules that apply in your country, in particular EN 60598-2-17.
•
If you lack the qualification, do not attempt the installation yourself, but instead use a professional installer.
Improper installation can result in bodily injury and or damage to property.
•
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions.
•
For overhead use, always secure the device with a secondary safety attachment such as a safety bond or
safety net.
•
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
device.
•
For commercial use the country-specific accident prevention regulations of the government safety
organization for electrical facilities must be complied with at all times.
Caution – material damage
•
This device must not be connected to the mains voltage by means of a dimmer.
•
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
•
Never switch the device on and off in short intervals. This will considerably reduce the service life of the
device.
•
If the device has been exposed to drastic temperature fluctuation, do not switch it on immediately. The
resulting condensation may destroy the device. Allow the device to reach room temperature before
connecting it. Wait until the condensation has evaporated.
•
Please use the original packaging to protect the device against vibration, dust and moisture during
transportation or storage.
•
If a serial number label is affixed to the device, do not remove the label as this would make the guarantee
void.
•
Never lift the fixture by holding it at the projector-head, as the mechanics may be damaged. Always hold
the fixture at the transport handles.
EU Declaration of Conformity
Steinigke Showtechnic GmbH hereby declares that this product (FUTURELIGHT DMH-160 MK2 LED
Moving-Head, Artikel-Nummer 51841972) is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU. The complete Declaration of Conformity can be found at
www.steinigke.de.