7
Setting Up the FUTREX-6100
Once you have verified that all of the components of the FUTREX-6100 have been
included in the box, the following steps should be taken to setup the instrument. Ensure you have
sufficient table space to complete the assembly.
1. Battery Installation
Insert six 1.5 "AA" size batteries into the battery compartment located on the rear of the main
body. Be sure the batteries are oriented as indicated in the battery compartment.
2. Connecting the Light Wand
Ensure the Light Wand Connector is attached to the Main Body Connector.
NOTE: Futrex recommends always leaving the Light Wand attached to the Main Body.
Figure 1 – Battery Installation and Light Wand Connection
3. Printer Paper Installation
Remove the clear plastic cover from the printer. Ensure the display reads "READY" or "ZERO
ADJUST". Start feeding the paper into the slit inside the Paper Roll Compartment by pressing
the PAPER FEED key.
Figure 2 – Printer Paper Installation
