OFF
H
H + V1
V1 + V2
H + V1 + V2
OFF
> 3°
> 3°
OFF
SAFETY
Use extreme caution when the laser beam is turned on.
Do not let the beam enter your eyes, another person’s eyes or the eyes of an an-
imal. Be careful that reflections of the beam (on a reflective surface) do not strike
your eyes.
Do not aim the laser beam at any gas that may explode.
Please read the complete safety instructions in the booklet delivered with this
device.
FIRST USE
Remove any protective films where applied.
Open the battery compartment [5] and insert the li-ion battery. (You can also use
4x AA alkaline batteries.) Please take care to respect the indicated polarity.
AC/DC SOCKET - POWER ADAPTOR AND BATTERY SYSTEM
The laser can be powered from main power directly when there is no battery in-
side the laser or when the li-ion batterie runs flat. Use the included power adapter
to provide continuous electricity to laser.
When connecting poweradaptor with AC/DC socket [9], power from li-ion battery
will be cut off automatically.
When using the AC/DC socket [9], the li-ion battery is
not charging!
You can use the MC3D Brave also with 4x AA Alkaline batteries, simply by replac-
ing the li-ion battery by 4x AA Alkaline batteries.
CHARGE LI-ION BATTERY
You can only charge the Li-ion battery by connecting the extra small cable to the
adapter and pluging this cable in the micro-usb-connector of the li-ion battery.
Only use the included charger to avoid damage.
HORIZONTAL AND VERTICAL ALIGNMENT
· Shift the On/Off-switch - Transportlock [4] to the left (two steps). The laser is
switched on and the pendulum levelling mechanism is released. Only the hori-
zontal laserline is activated when turning on the device.
The MC3D Brave is now able to align itself. Make sure the instrument is not
placed on a surface with more than 3° slope. If the slope of the instrument ex-
ceed 3°, the device beeps and the laser lines will flash.
Please flatten the position of your laser device until the beep stops. The laser
is now able to show automaticaly perfectly levelled laser lines (horizontal and
vertical).
· You can switch on or off additional/other lines (horizontal and vertical) using the
Line selection button [7].
· We advise to set the horizontal line on your working height.
NOTE
·
Cross line lasers Can only be used on tripods whiCh are adjustable in height,
suCh as Cranked or telesCopiC tripods.
·
if the workplaCe is very brightly lit, e.g. out doors, it may be neCessary to use
a laser reCeiver.
