18
This page is an explanation of when to make it into an engine.
(It is unnecessary in case of EP.)
Installation of Engine：GP kit only
1
1
1
1
1
2
1
3
5
6
● Screw the
Radial mount
to the firewall with a screw.
● Except for the set with engine, the radial mount is not
included. Purchase the engine mount separately according
to the engine to be used.
● Place the canopy on the fuselage and cut it if
there is a part interfering with the engine.
ٛ ŵƄƇƌƄƏŃƐƒƘƑƗ ٜ
● Fix the
Radial mount
securely with
4 × 20 screws
on the firewall,
Spring washers
and
Nut with Claw
.
ũƌƕƈƚƄƏƏ
● Drill a hole
i n t h e f u e l
pipe.
űƘƗŃƚƌƗƋŃŦƏƄƚ
ŰŖőŘƛŔřŃ ūƈƛƄƊƒƑŃ
ƖƆƕƈƚŃ ƄƑƇŃ ŶƓƕƌƑƊŃ
ƚƄƖƋƈƕŃŋŗŃƓƌƈƆƈƖŌ
● If it interferes, cut the
canopy with dremel etc.
4
آŧƘƖƗŃƄƑƇŃƖƋƄƙƌƑƊƖŃƐƘƖƗŃƑƒƗŃƈƑƗƈƕŃƌƑƖƌƇƈŃƗƋƈŃƈƑƊƌƑƈő
1
7
● The hole position varies depending on the engine
used. The figure is an example of an
O.S. two cycle
engine
.
8-1
ٴ
4 × 20 screws and Spring washers
● Drill a hole for
plug heat
.
● Cut the film.
＜ Fuselage nose bottom ＞
ŨƛƋƄƘƖƗŃƓƒƕƗ
ŶƌƏƈƑƆƈƕŃ ƖƆƕƈƚŃ
ƄƑƇŃűƈƈƇƏƈ
ŷƋƕƒƗƗƏƈŃƖƆƕƈƚ
● Place the engine and cut the interfering side plate
parts such as silencer and needle.
● Apply oil resistant paint or adhesive to the balsa after
cutting and take countermeasures.
● Fix the
Engine
using a
M3.5 x 16 hexagon screw
(4
pieces) and a
Spring washer
attached to the radial
mount.
● Cut the nose bottom film for engine cooling and
waste oil discharge.
In a typical airplane the propeller axis is offset to the right.
However, this plane is offset to the left. Resolve the peculiar
habit of this airplane with a left offset.
ůƈƉƗŃƖƌƇƈŃƗƋƕƘƖƗ
ũƌƕƈƚƄƏƏ
