13
PUSH
Ni-Cd battery pack
Charging jack
Battery cover
Battery connector location
Trainer function
/DSC function connector
RF module
To remove, press the tabs together
and gently pull rearwards.
To install, line up the connector pins with
the socket in the rear of the module and
gently snap into position.
Switch/Knob
Airplane (
ACRO
)
Sailplane/Glider (
GLID
)
Helicopter (
HELI
)
A or H Tx.
S
WITCH
A
elevator dual rate
elevator dual rate
elevator dual rate
down = butterfly on
Switch
B
rudder dual rate
rudder dual rate
rudder dual rate
Switch
C
up =
ELE-FLP
on
up =
ELE-FLP
on
governor/ch 7
center/down =
IDLE-DOWN
center/down =
IDLE-DOWN
down =
AIRBRAKE
on
S
WITCH
D
aileron dual rate
aileron dual rate
aileron dual rate
Switch
E
OR
G*
landing gear/ch 5
GLID1FLP
= gear
throttle hold
Switch
F
OF
H*
snap roll/trainer
trainer
trainer
/THR-CUT
S
WITCH
G
OR
E*
none
back =
SPEED OFFSET
idle-up 1 and 2
fwd =
START OFFSET
S
WITCH
H
OR
F*
none
none
idle-up3/ch 5/gyro
K
NOB
A
flap/ch 6
GLID1FLP
: flap
HOVERING PITCH
(flap trim if
FLAPERON
on)
(flap trim if
FLAPERON
on)
GLID2FLP
: camber
(flap trim if
FL-AIL
off)
K
NOB
B
ch 8
ch 8
ch 8
K
NOB
C
spoiler/ch 7
spoiler/ch 7
HOVERING THROTTLE
(disabled if
AIL-DIFF
on)
(disabled if
AIL-DIF
on)
S
LIDER
D
none
GLID1FLP
: ch 5
none
S
LIDER
E
none
none
none
*On the 9CH transmitters, the
T
OP
L
EFT
S
WITCHES
are spring-loaded and 3-position; on the 9CA, those switches are on the right side. For consistency,
the switch position’s designation remains the same (upper left is F, etc), but the functions are moved to match the switch type.
NOTE: If you need to remove or replace the transmitter battery, do not pull on its wires to remove it. Instead,
gently pull on the connector's plastic housing where it plugs into the transmitter.
SWITCH ASSIGNMENT TABLE
•
The factory default functions activated by the switches and knobs for a Mode 2 transmitter are shown below.
•
Most 9C functions may be reassigned to non-default positions quickly and easily.
•
Basic control assignments of channels 5-9 are quickly adjustable in
AUX-CH
(see pp. 39). For example, the channel 5
servo, which defaults to
S
WITCH
E
for retract use, can easily be unassigned (
NULL
) to allow for easy use as a second
rudder servo in a mix, or to a slider or dial for bomb door or other control.
•
Note that most functions need to be activated in the programming to operate.
•
Mode 1 transmitter functions are similar but reverse certain switch commands. Always check that you have the desired
switch assignment for each function during set up.
