59
Reverse servos as needed for proper
control operation. Ex:
L
EFT
R
UDDER
S
TICK
results in leading edge of tail
rotor blades moving left. Reverse to
operate properly. P. 30.
Adjust Travels as needed to match
model's recommended throws (usually
listed as high rates).
P. 31.
Activate
THR-CUT.
P. 66.
Set up throttle curve for normal.
2
(Usually changes will not need to be
made prior to first flight.) P. 65.
Set up collective pitch curve for
normal as base of -4, center of +5,
end of +8 to +10 degrees of blade
pitch for aerobatics.
2
(If just learning
to fly, ask your instructor.) P. 65.
Set up revo. mixing for normal. (For
heading-hold gyros, inhibit revo.) P. 65.
Confirm Gyro direction. (Note: if
using a heading-hold/AVCS gyro, use
the
GYRO
programming for proper
setup.) See p. 73.
In the
BASIC
menu, open
REVERSE
.
Choose desired servo and reverse its
direction of travel.
(Ex: reverse rudder servo.)
In the
BASIC
menu, choose
END POINT
.
Adjust the servo's end points.
(Ex: flap servo)
Return to
BASIC
menu.
Open
THR-CUT
function.
Activate the function. Choose desired
switch and position to activate.
With
T
HROTTLE
S
TICK
at idle, adjust the
rate until the engine consistently shuts
off, but throttle linkage is not binding.
1
Close.
Open the
THR-CV/NOR
function.
Adjust if needed. Close the function.
Open the
PIT-CV/NOR
function.
Adjust each point to match desired
curve. (Ex first point:
89%
.)
Close the function.
Open the
REVO-MIX
function. Adjust to
your desired starting point. (Ex:
10%
.)
Close the function.
to
REVERSE
.
to choose
REVERSE
.
to
CH4
:
RUDD
.
so
REV
is selected.
Repeat as needed.
to
END POINT
.
to choose
END POINT
.
to
to
O F F.
ELEV
.
E
LEVATOR
S
TICK
.
until up travel is as desired.
E
LEVATOR
S
TICK
.
until down travel is as desired.
Repeat as needed.
to
THR-CUT.
t o
S W
.
t o
A-D O W N
.
A
to down position.
T
HROTTLE
S
TICK
.
to
RATE
.
to
THR-CV/NOR
.
to
95%
.
to next point. Repeat.
to
PIT-CV/NOR
.
to
89%
.
to next point. Repeat.
to
REVO-MIX
.
to
10%
.
to
15%
.
With radio on, move helicopter' s tail to the right by hand.
The gyro should give right rudder input (leading edge of the tail rotor blades
move left).
If the gyro gives the opposite input, reverse direction on the gyro unit itself.
until shuts off.
to
ON
.
