PARAMETER
submenu
:
sets those parameters you would likely set once, and then not disturb again.
Once you have selected the correct model you wish to work with, the next step is
setting up the proper parameters for this specific model:
•
What is the model's type?
•
Assign the desired SW to CH5 and CH7.
First it is important to clear out any old settings in the memory from prior use, using the
MODEL RESET
.
MODEL RESET
:
completely resets all data in
the individual model you have currently selected.
Don't worry - there is no way
you can accidentally delete all models in your radio with this function. Only a service center can completely reset your
radio's entire memory at once. To delete each model in your radio's memory (for example when selling), you must
SELECT
each model, reset that memory, then go
SELECT
the next memory, etc.
Note that when you
COPY
one model memory into another or change the model's type, you need not delete all existing data
first by using this function.
COPY
completely overwrites anything in the existing model memory, including
MODEL NAME
.
The
MODEL TYPE
function overwrites all data except name.
GOAL of EXAMPLE:
STEPS:
INPUTS:
*Radio shows progress on screen as the model memory is being reset. Note that if the power switch is turned off prior to completion,
the data will not be reset.
28
Reset model memory 1.
NOTE: This is one of several
functions for which the radio requires
confirmation to make a change.
Where next?
Confirm you are currently using the
proper model memory. (Ex: 1)
Open
PARAMETER
submenu.
Reset the Memory.
Confirm the change
.
Close.
On home screen, check model name and
number on top left and right. If it is not
correct, use
MODEL SELECT
, p. 25.
for 1 second.
(If
ADVANCE
,
again.)
to 3rd page of menu.
to
PARAMETER
.
for one second.
sure?
displays. *
Now that the memory is reset, name has returned to the default (Ex:
MDL-01
).
NAME
the model: p. 27.
COPY
a different model into this memory: p. 25.
SELECT
a different model to edit or delete: p. 25.
Change the
MODEL TYPE
to helicopter: see p. 28.
Utilize servo
REVERSE
: see p. 30.
Adjust servo travel with
END POINT
: see p. 31.
Set up dual/triple rates and exponential (
D/R,EXP
): see p. 33.
