FUTABA 6EXP, Инструкция по эксплуатации

Страница: 21 / 37

21
To activate flap trim:
1. Enter the programming mode. Access the “ FLTR ” screen with the MODE key.
2. If “ INH ” is blinking, push DATA INPUT lever upward for 0.5 seconds. Then you will see that
the blinking “ INH ” changes to “ ON ”. Your flap trim is now turned on.
3. Set the travel of the flap switch at between -100% and +100% by using DATA INPUT lever.
Two rates (upward and downward of flap switch) are adjustable.
V-TL V-tail mixing (ACRO only)
*If necessary, use the Servo Reversing
function to achieve the correct direction of
servo throws.
Intended for V-tail aircraft (such as a Beechcraft Bonanza), V -tail mixing allows
the ruddervators to operate both as rudders and elevators. The same as the other
mixes, V -tail mixing requires that each ruddervator be operated by a separate
servo.
To activate V-tail mixing:
1. Connect the left ruddervator servo to channel 2 (elevator) in the receiver and connect the
right ruddervator servo to channel 4 (rudder) in the receiver.
2. Enter the programming mode. Access the “ V-TL ” screen with the MODE key.
You cannot set “ V-tail ” mixing when “ Elevon ” mixing has already been set. In order to enable
“ V-tail ” mixing, you first need to cancel “ Elevon ” mixing. However, it is allowed to use “V-Tail”
and “Flaperon” mixing simultaneously.
3. Push the DATA INPUT lever upward for 0.5 seconds. This will cause the flashing “ INH ”
display to change to a flashing “ ON ” display. Now the mixing is on.