15
ACRO/HELI Model type select function
The Model type select function is used to select the
ACRO
or
HELI
mode of model type.
ACRO
: Powered aircraft memory type (with multiple wing and tail configurations. See Wing mixing type selection for further
information, p20.)
HELI
: Helicopter memory type (with three helicopter swashplate type. See Swashplate types selection for further information,
p28.)
CAUTION
: Before doing anything else to set up your aircraft, first you must decide Model type (include wing mixing type or
swashplate type) best fits this particular aircraft.
To select model type:
1. Access the Model Select function in the programming mode (by pressing the MODE and
SELECT keys simultaneously and holding them down for one second). To select the model
memory you wish to select model type press the DATA INPUT lever and hold it down for 0.5
seconds until the desired model number appears.
2. Push SELECT key twice after seeing on the screen the model memory where you want to
select model type, then you will see “ACRO” or “HELI” on the screen.
3. To change model type, push the DATA INPUT lever and hold it down for about two seconds.
“HL” and “AC” blinks first, and then it stops blinking with a sound. The current model type
“ACRO”
or
“HELI”
is displayed.
PULS Modulation select function
The Modulation select function is used to select the
PPM
or
PCM
mode of transmission, to
match the receiver being used (PPM-Pulse Position Modulation, also called FM for Frequency
Modulation, and PCM-Pulse Code Modulation).
To select modulation:
1. Access the Model Select function in the programming mode (by pressing the MODE and
SELECT keys simultaneously and holding them down for one second). To select the model
memory you wish to modulation select press the DATA INPUT lever and hold it down for 0.5
seconds until the desired model number appears.
2. Push SELECT key three times after seeing on the screen the model memory where you
want to set modulation, then you will see “PULS” on the screen.
3. To select PCM modulation, push the DATA INPUT lever up. The
“PCM”
is displayed. To
select PPM modulation, push the DATA INPUT lever down. The
“PPM”
is displayed.
4. To get the transmitter to operate in the new mode, switch transmitter power off and then on.
The small indicator will indicate the mode, either PPM or PCM.
TRNR Trainer function (ACRO only)
The Trainer function is used to activate the trainer switch each model memory as the
instructors’ transmitter. See Trainer switch for further information, p33.
To activate trainer function:
1. Access the Model Select function in the programming mode (by pressing the MODE and
SELECT keys simultaneously and holding them down for one second). To select the model
memory you wish to activate trainer function press the DATA INPUT lever and hold it down
for 0.5 seconds until the desired model number appears.
2. Push SELECT key four times after seeing on the screen the model memory where you want
to activate trainer function, then you will see “TRNR” on the screen.
3. To activate the function, push the DATA INPUT lever up for 0.5 seconds. The
“ON”
is
displayed. To inhibit the function, push the DATA INPUT lever down for 0.5 seconds. The
“INH”
is displayed.
