FUTABA 3PL-2.4G, Инструкция по эксплуатации

Страница: 15 / 28

15
Assembly / Adjustment
Transmitter Set-Up Procedures
*When making these setting adjustments, do so with the motor disconnected or
the engine not running.
NEUTRAL, HIGH, AND BRAKE MAX POINTS SETTINGS
Before setting each point, set the transmitter throttle channel trim to neutral.
Turn on the power in transmitter -> amp order.
1
2
Transmitter throttle operation
･ Neutral state
･ Press the pushbutton switch.
(0.5 secs or longer)
(Confirmation beep sounds)
･ Continuous single blink
MC230CR /MC330CR
(Pushbutton switch operation) (Checker LED)
N
N
Full High
Full brake N
Neutral point
setting
3
･
Full high state
･ Press the pushbutton switch.
(Confirmation beep sounds)
･ Continuous double blink
･
Continuous rapid blink
High point
setting
4
･ Full brake state
･ Press the pushbutton switch.
(Confirmation beep sounds.)
･ If the LED goes out,
setting is complete.
Brake MAX
point setting
* Since the data is read at the end of setting of all points, the points cannot be set independently.
* If the amp power was turned off during setting, the setting points cannot be memorized. (The previous settings are retained.)
* The confirmation beep sounds only when the motor was connected.
If the LED does not go off
but blinks rapidly, setting
was not performed
normally. Repeat setting
from "Neutral point
setting".
Set the steering angle adjustment function (ATV) to
100% and the ABS function and acceleration function
to OFF using the transmitter throttle channel function.
If the steering angle is too large or the ABS and acceleration
functions are on, erroneous operation may occur.
*When using the ABS function, after setting up
the MC230CR / MC330CR, stop the reverse
function, then turn on the ABS function. If the
ABS function is on, the MC231CR / MC331CR
cannot be set up correctly.
(Preparations)
Select the model memory that is not used and reset it to the initial values with the model
selection and model reset functions.
Model number
（ 1 - 0 ）
Model name
(Selection key)
Model Selection Model Reset
Push the DT2 lever up or down
for about one second.
All data stored in the current
selected model memory is
erased.
Servo Horn Installation Instructions
1 Connect the receiver, servos, and other components and then
turn on the power switches to the transmitter and receiver.
*Both servos will move to the neutral position.
2 At this time install the servo horn in the manner described in
the instruction manual provided with the model this system
will be used in.
Reversing The Servo Operation Direction
NOR: Normal
REV: Reverse
(Selection key)
Steering Servo Reverse
NOR: Normal
REV: Reverse
(Selection key)
Throttle Servo Reverse
S h o u l d t h e s e r vo o p e ra t e i n t h e o p p o s i t e
direction required for your application, reverse
the direction with the servo reversing.
E.S.C. MC230CR / MC330CR