12
Assembly / Adjustment
Digital Proportional Adjustment
*When making these settings adjustments , do so with the motor disconnected
or the engine not running.
Servo Horn Installation Instructions.
1
Connect the receiver, servos, and other components and
then turn on the power switches to transmitter and receiver.
2
Be sure the Steering trim and Throttle trim on the transmitter
are at their neutral position .
3
At this time install the servo horn in the manner
described in the instruction manual provided
with the model this system will be used in.
Both servos will move to the neutral
position.
Reversing The Servo Operation Direction
Should the servo operate in the opposite direction required
for your application, reverse the rotation with the reversing
switch.
E.S.C. MC230CR / MC330CR
(Reversing Switches)
Throttle
N Side: Normal
R Side: Reverse
Steering
N Side: Normal
R Side: Reverse
(T2PH)
(T2PHKA)
NEUTRAL, HIGH, AND BRAKE MAX POINTS SETTINGS
Before setting each point, set the transmitter throttle channel trim to neutral.
Turn on the power in transmitter -> amp order.
1
2
Transmitter throttle operation
･
Neutral state
･
Press the pushbutton switch.
(0.5 secs or longer)
(Confirmation beep sounds)
･
Continuous single blink
MC230CR /MC330CR
(Pushbutton switch operation)
(Checker LED)
N
N
Full High
Full brake
N
Neutral
point setting
3
･
Full high state
･
Press the pushbutton switch.
(Confirmation beep sounds)
･
Continuous double blink
･
Continuous rapid blink
High point
setting
4
･
Full brake state
･
Press the pushbutton switch.
(Confirmation beep sounds.)
･
If the LED goes out,
setting is complete.
Brake MAX
point setting
* Since the data is read at the end of setting of all points, the points cannot be set independently.
* If the amp power was turned off during setting, the setting points cannot be memorized. (The previous settings are retained.)
* The confirmation beep sounds only when the motor was connected.
If the LED does not go off
but blinks rapidly, setting
was not performed
normally. Repeat setting
from "Neutral point
setting".
Set the steering angle adjustment function (ATV) to
100% and the ABS function and acceleration function
to OFF using the transmitter throttle channel function.
If the steering angle is too large or the ABS and acceleration
functions are on, erroneous operation may occur.
*When using the ABS function, after setting up
the MC230CR / MC330CR, stop the reverse
function, then turn on the ABS function. If the
ABS function is on, the MC230CR / MC330CR
cannot be set up correctly.
