7
Before Operation
Transmitter T2PH / T2PHKA
Nomenclature / Handling
(T2PH)
(T2PHKA)
Antenna
Trim Panel Cover
Battery Level
Indicator
*Two LED display to indicate
battery voltage level.
*If the Red led flashes, replace
batteries.
*Open the cover by sliding it
to the left.
Steering Trim (P13)
Steering Wheel
Throttle Trigger
Grip Handle
¥ Servo Reversing Switch (P13)
¥ Steering EPA (only 2PHKA) (P14)
¥ Throttle EPA (only 2PHKA) (P14)
¥ Steering D/R (only 2PHKA) (P14)
Power Switch
Throttle Trim (P13)
*When slid upward,
the power is turned on.
*Adjusts the steering in small increments
so the model will run straight.
*Turn model to left or right.
*Adjusts the throttle in small increments
so the model will not move at neutral.
*Control the speed of the model and movement
forward and backward.
E.S.C. MC230CR
/ MC330CR
Motor connector
Connects to the motor.
(Orange) is plus. (Blue) is minus.
If the motor rotates in the wrong
direction, interchange the connections of
this connector.
Nicd battery connector
Connects to the running Nicd battery.
(Red) is plus. (Black) is minus.
Receiver connector
Connects to the receiver throttle channel.
Miniature screwdriver
Accessory. Use to press the
pushbutton switch.
Checker LED
Power switch
Pushbutton
switch
MC230CR
(Orange)
(Blue)
(Black)
(Red)
Applicable motors
(Number of turns is criteria.)
•Use the MC230CR with a motor with 20T or more turns.
•Use the MC330CR with a motor with 13T or more turns.
*If a motor with a number of turns smaller than the above is used, the heat
protector and overcurrent protection circuit may operate. The number of turns
of the motor is a criteria only. Depending on the running conditions, the
protection circuit may operate even if the condition above is satisfied.
Nicd battery 6~7 cells (7.2~8.4V)
