69
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
R T N
b u t t o n .
O r t h e
H O M E / E X I T
b u t t o n i s
pushed.
<SensorTouch™>
RETURN
MODEL SELECT
The Model Selection function performs model addition, selection,
deletion, copy, and model name setting.
This function is used to load the settings of the
desired model into the T14SG’s memory.
The settings may be selected from either the
transmitter’s internal memory or an SD card.
Remember that up to 30 model memories are available
in the transmitter.
The name of the model stored in the transmitter and
the SD card may be changed. This can be very useful
to tell different models settings apart. Each model name
can be as long as 10 characters, and the model name
always appears in the display screen.
The Copy function is used to copy parameters,
settings, etc. from one model data into a second
memory. It may be used for getting a head-start on
setting up models with almost the same settings (only
differences need to be modified, instead of entering the
complete model from scratch). Also, this function may
be used to make a backup copy of a model setup before
any changes are made.
*T14SG can use the model data of T8FGS for SD card,
copying it. However, the model data of T14SG cannot be
used by T8SG (S).
Model selection
*Model data saved on the transmitter memory other than the
model currently used can be selected.
1. Move the cursor to the save destination
display ("TX" or "CARD") and touch the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
touch sensor and touch the RTN button.
[TX]: Transmitter memory
[CARD]: SD card
2. After moving the cursor to the desired model
in the model list, touch the RTN button.
3. Move to [SELECT].
4.Touch the RTN button. A confirmation
message is displayed. Touch the RTN button
for one second and selection is complete.
*Transmission stops and then starts in the new model.
Model addition
*A new model can be added to the transmitter memory. It can
not be added to the SD card.
1. Move the cursor to [NEW].
2. Touch the RTN button. A confirmation
message appears. Touch the RTN button for
one second.
*The model type setup screen and frequency setup screen are
automatically displayed. Confirm or change the model type
and SYSTEM mode.
*Transmission stops and then starts in the new model.
*The added model appears in the model list of the model
select setup screen.
*Link is required when a new model is
made from a model selection.
● Select [MODEL SELECT] in the Linkage menu
and access the setup screen shown below by
touching the RTN button.
*The display screen is an example. The
screen depends on the model type.
Scrolling
● Moving cursor
● Selecting mode
(Model list)
Current model
