FUST PRIMOTECQ TA 506 E, Руководство пользователя

Страница: 40 / 42

40
mm) in the lowest point of the hose and to place
a small container below it.(See picture, point B).
Once connected to the
dryer, run the vent hose to
the desired outlet point,
ensuring that the run’s
overall length is less than
2 m, and that it contains
no more than two bends.
As to the outlet itself, if
you have decided on a fixed wall/window grille, a
good local builder’s merchant should be able to
supply you with the necessary fittings and
installation advice.
Important:
It is important not to
connect the vent hose to,
for example, a cooker
hood, or a chimney or flue
pipe designed to carry the
exhaust from a fuel
burning appliance.
Note that to avoid condensation problems, it is
essential that the dryer be fitted with the flexible
hose to carry its “exhaust” at least beyond the
kitchen units; preferable outside the kitchen. In
order to prevent the appliance from overheating,
it is important that the steam exhaust is
unobstructed. Therefore, in case of a permanent
hose fitted to an exterior wall or ceiling, it must be
ensured an exhaust capacity of at least 150
m3/h. If the dryer is fitted next to kitchen units,
make sure that the vent hose is not squashed. If
the hose is partially squashed, drying efficiency
will be reduced, resulting in longer drying times
and higher energy consumption. If the hose is
completely squashed, the safety cut-outs with
which the machine is fitted may operate. When
operating the tumble dryer, the room temperature
must not be lower than +5°C and higher than
+35°C, as it may affect the performance of the
appliance.
Electrical connection
This machine is designed to operate on a 220-
230 V, single-phase, 50 Hz supply. Check that
your domestic electrical installation can take the
maximum load required (2.2 kW), also taking into
account any other appliances in use.
Connect the machine to an earthed socket, in
accordance with current wiring regulations.
Important:
The manufacturer declines any responsibility
for damage or injury through failure to
comply with the above safety precaution.
Should the appliance power supply cable
need to be replaced, this must be carried out
by our Service Centre.
Important:
The power supply cable must be accessible
after installing the machine.
Stacking kit
A special stacking kit is available through your
dealer, to enable the mounting of the dyer on top
of a front loading washing machine with cover’s
depth between 48 and 60 cm.
Read carefully the instructions supplied with the
kit.
Door reversal
To make it easier to load or unload the laundry
the door can be reversed.
280
055
056
B