21
8
RICERCA GUASTI
I
1) L’apparecchio non funziona
• C’è un’interruzione di corrente?
• La spina è ben inserita nella presa di corrente?
• Il cavo di alimentazione è danneggiato?
• Il termostato è sulla posizione Stop?
2) La temperatura all’interno dei comparti non è sufficientemente bassa
• Le porte chiudono correttamente?
• L’apparecchio è installato vicino ad una sorgente di calore?
• Il termostato è sulla posizione corretta?
• Il condensatore è pulito?
3) La temperatura all’interno del comparto frigo è troppo bassa
• Il potenziometro è sulla posizione corretta?
4) C’è acqua sul pavimento
• La vaschetta
V
è ben inserita a contatto della superficie del compressore?
Per liberare lo scarico dell’acqua di sbrinamento riferitevi al cap.7
1) The appliance is not working
• Is there a power failure?
• Is the plug inserted correctly into the mains socket?
• Is the supply cable damaged?
• Is the thermostat set in the
STOP position?
2) The temperature inside the compartments is not low enough
• Do the doors close correctly?
• Is the appliance installed near a source of heat?
• Is the thermostat set in the correct position?
• Is the condenser clean?
3) LThe temperature in the refrigerator compartment is too low
• Is the temperature dial in the correct position?
4) here is water on the floor
• Is the container
V
placed properly against the surface of the
GL0910-210
GF0312-240
5) L’apparecchio è eccessivamente rumoroso
• L’apparecchio è in contatto con altri mobili, o oggetti?
• I tubi nella parte posteriore si toccano o vibrano?
• L’apparecchio è ben livellato?
6) La luce interna non funziona
• Controllate prima il punto 1 e poi:
compressor?
To clear the drain for the water generated by the defrosting process,
please see chapter 7.
5) The appliance is too noisy
• Is the appliance touching other pieces of furniture or objects?
• Are the tubes at the back touching each other or do they vibrate?
• Is the appliance on a level?
6) The interior light does not work
• First check point 1, then:poi:
Sostituzione lampada (fig. 18-19)
• Disinserite l’apparecchio dalla rete elettrica
• Togliete il coperchio della lampadina
• Controllate la lampadina e sostituitela , se necessario, con una
nuova (15W max)
22
23
Lamp replacement (fig.18-19)
• Disconnect the appliance from the mains supply.
• Remove the cover from the light bulb.
• Check the light bulb and if necessary, replace it with a new one
(15 W max).
GF0312-222
GF0312-232
8
TROUBLESHOOTING
GB
V
Содержание KS OLDI 270 IB
Страница 31: ......
Страница 32: ...940 Stampa TLF 0 4 6 4 0 3 1 6 4 12 10 2012 ...