Fusion PS-A302B, Инструкция по установке

Страница: 3 / 4

Side View
Dimension Measurement
50 mm (1.97 in.)
41 mm (1.6 in.)
Specifications
Ingress protection rating* IEC 60529 IP65
Dimensions with trim (W × H × D) 344 x 155 x 50 mm (13.54 x
6.1 x 1.97 in.)
Weight 1.15 kg (2.54 lb.)
Operating temperature range From 0° to 50°C (from 32° to
122°F)
Long-term storage temperature
range From -20° to 70°C (from -4° to
158°F)
Bluetooth
®
wireless range Up to 10 m (33 ft.)
ANT ® wireless range Up to 3 m (10 ft.)
Input voltage From 10.8 to 16.0 Vdc
Current (max.) 10 A
Fuse 10 A
Line output level (max.) (peak to
peak) 5.5 V
Aux. input level (typical) RMS 1 V
*IP rating does not include rear connectors.
Compass-Safe Distances
All stereo speakers contain magnets which may cause
interference with instruments on your vehicle or vessel. The size
of the magnet used in the stereo speakers affects how much
interference the stereo speakers may cause.
Interference can cause deviations and variations in the readings
of sensitive navigational equipment, such as magnetic
compasses. These deviations can cause inaccuracies or offsets
in the readings, but will not harm the equipment. To alleviate the
deviations, adjust the compass for the deviation following the
manufacturer's instructions or move the stereo away from the
navigational equipment. After moving a source of interference,
you may need to recalibrate the compass.
If you are navigating solely by a magnetic compass, use
extreme caution to place the stereo far enough away from the
compass to avoid causing deviations in the readings.
To avoid deviations to navigational equipment, position the
stereo so it is separated from the navigational equipment by at
least the distances listed in the table below.
Direction from Speaker Compass-safe Distance
122 cm (4 ft.)
105 cm (3.5 ft.)
229 cm (7.6 ft.)
138 cm (4.5 ft.)
112 cm (3.8 ft.)
214 cm (7 ft.)
Troubleshooting
Before you contact your FUSION dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the FUSION stereo has been professionally installed, you
should contact the installer so a technician can assess the
problem and advise you about possible solutions.
The audio is distorted
• Verify that the panels surrounding the stereo on the vehicle
or vessel are not rattling.
• Verify that the source volume is not too loud, and reduce the
volume if necessary.
• Verify that all RCA connections are in good condition, and the
connectors are insulated from each other.
• Verify that all cables are properly attached.
© 2018 Garmin Ltd. or its subsidiaries
Garmin
® , the Garmin logo, FUSION ® , the Fusion logo, and True-Marine ™ are trademarks
of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. These
trademarks may not be used without the express permission of Garmin.
Important Safety Information 3