6
7
ALARM FEATURE “II” PROGRAMMING:
1.
Turn the Ignition ‘switch ‘ON/OFF’ 3 times (within 15 seconds),
and leave in the OFF position.
2.
Push the valet switch 4 times and hold on the 4th push until two short
chirps and one long chirp is heard, and then release the valet switch.
You are now in the alarm feature ‘II’ programming mode.
3. A;
Press and release the remote button corresponding to the
feature ‘1’ to be changed.
The siren will chirp and the LED will indicate the new setting.
B;
Press and release the remote button corresponding to the
feature ‘2’ to be changed.
The siren will chirp and the LED will indicate the new setting.
C;
Press and release the remote buttons + corresponding to
the feature ‘3’ to be changed.
The siren will chirp and the LED will indicate the new setting.
Note:
The factory default setting is always [1] LED flash, [1] chirp.
Press
remote
button
One Chirp /
LED one flash
Factory
Default Setting
Two Chirps /
LED two flashes
Three Chirps /
LED three flashes
1
0.9 - second
door lock
pulses
3.0 - second
door lock pulse
double pulse
unlock
2
Active arming
Passive arming
without passive
door locking
Passive arming
with passive door
locking
3 +
Ignition
controlled door
locks & unlocks
Without ignition
controlled door
locks & unlocks
Exit Programming:
Turn ignition to ‘ON’ position, or wait for
15 seconds. Three long chirps will confirm exit.
ALARM FEATURE “III” PROGRAMMING:
1.
Turn the ignition ‘switch ‘ON/OFF’ 3 times (within 15 seconds),
and leave in the OFF position.
2.
Push the valet switch 6 times and hold on the 6th push until three
short chirps and one long chirp is heard, and then release the valet
switch. You are now in the Alarm feature ‘III’ programming mode.
3. A;
Press and release the remote button corresponding to the
feature ‘1’ to be changed.
The siren will chirp and the LED will indicate the new setting.
B;
Press and release the remote button corresponding
to the feature ‘2’ to be changed.
The siren will chirp and the LED will indicate the new setting.
C;
Press and release the remote buttons + corresponding to
the feature ‘3’ to be changed.
The siren will chirp and the LED will indicate the new setting.
Note:
The factory default setting is always [1] LED flash, [1] chirp.
Press remote
button
One Chirp / LED one
flash
Factory Default
Setting
Two Chirps / LED
two flashes
1
Shock sensor
program mode
2
Red/white wire =
trunk/boot (Channel
3) output
Red/white wire =
two step door unlock
output
3 +
Anti car jacking off
Anti car jacking on
Exit Programming:
Turn Ignition to ‘ON’ position, or wait for 15
seconds. Three long chirps will confirm exit.
