Fusion Apollo MS-RA770, Руководство пользователя

Страница: 34 / 50

Source Settings
Select > SETTINGS > SOURCE , and select the name of the source you want to configure.
NOTE: This menu contains system-wide source settings. Most sources also have source-specific settings. See
the sections of this manual for each source for more information about source-specific settings.
Not all options are available for every source on the stereo.
SOURCE ENABLED : Enables and disables the source on this stereo. You may want to disable sources that will
never be used on the stereo so they no longer appear on the source-selection screen.
GROUP ENABLED : Enables and disables the sharing of the source when connected to other stereos in a
group ( Fusion PartyBus Networking , page 21 ). You may want to disable sharing for some sources, such as
Optical, because streaming over the Fusion PartyBus network introduces a small audio lag that is not
desirable in some situations.
SOURCE NAME : Changes the name of the source as it appears on this stereo. This also affects how the
source appears to other stereos in a group.
Network Settings
TIP: You can select the network status icon from any screen to open the network configuration menu.
Select > SETTINGS > NETWORK .
WI-FI OFF : Turns off all Wi
‑
Fi wireless functions.
WI-FI CLIENT : Configures the stereo as the wireless client, allowing it to wirelessly connect to other devices.
WI-FI ACCESS POINT : Configures the stereo as the wireless access point ( Setting the Fusion PartyBus Device
as a Wireless Access Point , page 29 ).
ADVANCED : Allows you to set the advanced wireless and wired settings, such as DHCP and SSID ( Advanced
Network Configuration , page 30 ).
RESET : Resets all network settings for this stereo to the factory default values.
Connecting the Fusion PartyBus Device to a Wireless Access Point
You can connect this device to a wireless access point on a router or compatible Fusion PartyBus device on the
network. This device can connect using Wi
‑
Fi Protected Setup (WPS), if it is supported by your access point
( Connecting the Device to a Wireless Access Point Using Wi
‑
Fi Protected Setup , page 28 ). This device can
connect using Apple Accessory Configuration (WAC) using a supported Apple device ( Connecting the Device to
a Wireless Access Point Using Apple Wireless Accessory Configuration , page 29 ).
1 Select > SETTINGS > NETWORK > WI-FI CLIENT > SSID .
A list of wireless access points within rage appears.
2 Select the Fusion PartyBus wireless access point.
3 If necessary, select PASSWORD , enter the password, and select .
4 Select SAVE .
NOTE: When you connect the stereo to a wireless access point, you cannot use the wired network connection.
Connecting the Device to a Wireless Access Point Using Wi
‑
Fi Protected Setup
If it is supported by your wireless access point, you can connect this device using Wi
‑
Fi Protected Setup (WPS)
instead of manually selecting the SSID and entering the password.
NOTE: You may need to see the owner's manual for your wireless access point for information about enabling
WPS.
1 Select > SETTINGS > NETWORK > WI-FI CLIENT > WPS .
2 Enable the WPS connection on your wireless access point.
NOTE: When you connect the stereo to a wireless access point, you cannot use the wired network connection.
28 General Settings