Fusion Apollo MS-RA770, Руководство пользователя

Страница: 36 / 50

Wireless Access Point Settings
Select > SETTINGS > NETWORK > ADVANCED > WI-FI ACCESS POINT .
NOTE: You must configure the device to be a wireless access point before you can change the settings ( Setting
the Fusion PartyBus Device as a Wireless Access Point , page 29 ).
SSID : Sets the SSID, or name, for the network.
AP SECURITY : Sets the type of wireless security protocol used by the access point.
NOTE: It is strongly recommended that you set the AP SECURITY using WPA2 PERSONAL. It is the most
widely-used and secure wireless security protocol.
PASSWORD : Sets the password for the access point. This is not available when the AP SECURITY setting is
set to NONE.
COUNTRY : Sets the region where the stereo is located. Different regions may use different channels on the
wireless spectrum, so you should set this to best accommodate local wireless devices.
CHANNEL : Sets the access point to use a group of channels in the high, low, or middle range of the available
spectrum for your region. You may experience better performance if you set the channel in a range with
fewer broadcasting access points.
DHCP SERVER : Sets the device to act as a wireless access point and the DHCP server on the network ( DHCP
Settings , page 31 ).
WPS : Initiates a Wi
‑
Fi Protected Setup (WPS) connection. Devices with a WPS button or setting can connect to
the access point on this stereo when the WPS connection is active.
NOTE: It can take up to two minutes to successfully connect to the access point after you select WPS.
Advanced Network Configuration
You can perform advanced networking tasks on a Fusion PartyBus device, such as defining DHCP ranges and
setting static IP addresses.
Select
> SETTINGS > NETWORK > ADVANCED .
DHCP CLIENT : Sets the device as a DHCP client. This is the default setting for all devices that are not
configured to be a DHCP server or wireless access point.
STATIC IP : Allows you to set a static IP address for the device ( Setting a Static IP Address , page 32 ).
GARMIN MARINE NETWORK : Allows the device to be used on a Garmin Marine Network so it can be viewed
and controlled by connected Garmin chartplotters ( Configuring the Stereo for use with a Garmin Marine
Network , page 31 ).
DETAILS : Shows information about the network configuration.
30 General Settings