Fusion 5100L, Инструкция по эксплуатации

Страница: 6 / 36

6
register this product online at www.swingline.com
getting ready to laminate
Easy Set Up
1 Remove the plastic exit tray from the box and place into the two holes on the back of the
laminator and extend to use. Ensure that there is sufficient space behind the laminator for the
item to be removed.
2 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
3 The laminator will briefly flash the Swingline GBC logo on the control panel and will make an
audible beep.
4 To use the laminator gently tap the ‘power on’ button.
NOTE: Your new laminator may emit
a slight odor during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
Manual Select ( ) – scroll through and select the required micron setting, i.e. 3 mil.
NOTE: If 1.5 mil setting is selected
ALWAYS use a carrier.
Interactive Menu Selection
5 A Swingline GBC logo will show in the screen followed by the main menu:
MANUAL SELECT AUTO POUCH SELECT
SETTINGS HELP
NOTE: Use arrows to scroll up/down and left/right, use ENTER
button to select.
Use at anytime to go back – one screen at a - time to the
main menu.
English