14
Malfunction
Cause
Rectification
Clipper cuts badly
or not at all
Clipper blade is blunt
Have top and bottom blades re-
sharpened by service centre (S)
Clipper blades have not been
correctly ground
Clipper blades are not oiled
Oil clipper blades every 15 minutes
The animal‘s hair is wet
Only clip dry hair
Hairs jammed between top and
bottom blades
Take off clipper head, push the top
blade half away from the clip- per head,
take away hairs between top and
bottom blade
Clipper head has too little
clipping pressure
Have clipper head inspected (S)
Motor does not
work
Faulty motor and / or electronics Have motor and / or electronics
replaced (S)
Clipper head blocked
Clean and oil clipper head
Motor runs very
slowly
Clipper blades were not
oiled sufficiently
Oil clipper blades
Running time of a
fully charged
battery is too short
and / or blades are
getting hot
Clipper blades were not
oiled sufficiently
Oil clipper blades
Dead, not fully charged or
defective battery has been used
Only use intact and completely charged
original battery
The control light of
the charging
station in not on
Charging station is not
connected to the power supply
Connect the charging station to the
power supply
Charging station is faulty
Have charging station inspected (S)
When the battery
is fully charged,
the light does not
change from red to
blue
Contacts of battery and / or
charging station are dirty
Clean contacts
Faulty battery
Replace battery
Contacts of the charging station
are deformed
Have the charging station re- paired
(S)
CARE AND MAINTENANCE
The cleaning and maintenance procedure must be carried out after every use.
All maintenance or blade change operations must be carried out with the appliance
switched OFF and removed from the mains adapter.
Never immerse the appliance in water.
After every use, remove the guide comb then use the small brush to eliminate any hair
from the cutting head and its seat.
Clean the outside of the appliance with a soft cloth. Never use solvents or abrasive
detergents.
Remove the cutting blade (fig. 20, 21). and evenly oil the blades and the seat of the motor
pin which is located on the inside.
