Furuno TZT19F, Руководство по установке

Страница: 38 / 58

3. HOW TO SET UP THE EQUIPMENT
3-6
Manual Fuel Management Setup
[Initial Setup] menu - [YAMAHA ENGINE SETUP]
[Initial Setup] menu - [IF-NMEAFI SETUP]
Menu item Description Options (setting range)
[Total Fuel Capacity] Enter the total fuel capacity of your
tank(s). 0 to 9,999(L).
[Manual Fuel Manage-
ment] Set to [ON] for manual fuel manage-
ment. See the Operator’s Manual. [OFF], [ON].
Menu item Description Options (setting range)
[Trip & Mainte-
nance] Reset fuel used, trip distance, engine trip and
maintenance hours (trip hour, standard hour,
optional hour, total hour). [Trip Fuel & Distance]: [Fuel
Used], [Trip Distance].
[Trip & Maintenance Hours]:
[Port], [Starboard].
[Trim Level Calibra-
tion] Trim all engines to fully down position (zero).
If trim level is not zero, tap [SET] to set trim
level to zero. –
[Fuel Flow Calibra-
tion] If the fuel flow indication (gph=gallons per
hour) is wrong, you can calibrate the indica-
tion to show correct flow. Enter a negative val-
ue if the indication is higher than actual; a
positive value if the indication is lower than ac-
tual. -7 to +7
[Engine Interface
Software Ver. & ID] Display engine interface software version and
ID. –
[Reset Engine Inter-
face] Reset engine interface. –
[Reset Engine In-
stance] Reset engine instance. –
[Reset Number of
Engines] Enter number of engines. [1], [2], [3], [4], [4P], [4S]
[Trouble Codes] Display trouble codes. For Yamaha engine
trouble codes, see the manual for the Yamaha
engine. –
Menu item Description Options (setting range)
[Select IF] Select [IF-NMEAFI] to set the analog data that is input from the IF-NMEAFI.
The setting is made after restarting the IF-NMEAFI.
[Category] Select the use (category) for this sensor. [Wind], [ST800_850], [Fuel],
[FreshWater], [WasteWater],
[LiveWell], [Oil], [BlackWater]
[Resistance Full] The resistance, in Ohms, when the tank is full. 0 (ohm) to 500 (Ohm)
[Resistance Mid] The resistance, in Ohms, when the tank is half
full. 0 (ohm) to 500 (Ohm)
[Resistance Empty] The resistance, in Ohms, when the tank is
empty.
0 (ohm) to 500 (Ohm)
[Capacity] The capacity of the tank. 0 (G) to 2650 (G)
[Self test] Test results are displayed.
[Set Hardware to
Factory Default] Resets the converter selected at
[Select IF] to factory default. [OK], [Cancel]