Furuno NAVpilot-611, Руководство по установке

Страница: 35 / 68

3. ADJUSTMENTS
3-7
RUDDER LIMIT SETUP
PORT: 10
STBD: 10
SET CENTER RUDDER POSITION
PORT RUDDER LIMIT SETTING
-TURN HELM HARD-OVER TO PO
RT AND SET MEASURED RUDDER
ANGLE VALUE.
(USUALLY 20 TO 45 DEGREES)
PUSH MENU KEY TO RETURN
TO PREVIOUS MENU.
Adjust RRU menu
3. Turn the helm to port direction completely to the hard over point.
4. Rotate the course control knob to select “PORT”.
5. Press the course control knob and the “10” for PORT is circumscribed with a double
rectangle.
6. Rotate the course control knob to set your boat’s maximum rudder angles referring to its
specifications or your best estimation.
7. Press the course control knob.
8. Turn the helm to starboard direction completely to the hard over point.
9. Rotate the course control knob to select “STBD”.
10. Press the course control knob and the “10” for STBD is circumscribed with a double
rectangle.
11. Rotate the course control knob to your boat’s maximum rudder angles referring to the
specification or your best estimation, and then press the course control knob.
12. Rotate the course control knob to select “SET CENTER RUDDER POSITION”.
13. Turn the helm to the approximate rudder center or zero degree position.
Note: The final precise rudder center position will be set during the SEA TRIAL menu
operation.
14. Press the TURN/MENU key to close the ADJUST RRU menu.
While adjusting the rudder angle, the message “ADJUSTING RRU- PLEASE WAIT” appears
on the other control units connected.
3.2.9 Setting rudder auto movement limit
AUTO RUDDER LIMIT determines the maximum rudder movement in degrees from the mid
position in the AUTO or NAV mode.
Note:
This setting must less than the rudder limit values set in the previous step. It is
recommended to set this value approximately 10º-15º less than the maximum rudder
limit values. If necessary, this value may be increased if more rudder is required for
the fishing mode.
1. Rotate the course control knob to select “AUTO RUDDER LIMIT”.
2. Press the course control knob and the current value is circumscribed with a double
rectangle.
3. Rotate the course control knob to set the rudder limit desired. (Setting range: 1 to 45°)
4. Press the course control knob.