Furuno GP-330B, Руководство оператора

Страница: 12 / 52

1. INSTALLATION
5
1.4.3 Flush Mount
See the outline drawing for mounting hole dimen-
sions and fixing instructions.
1. Remove the label from over the GPS receiver's
socket. (The label may be discarded.) Apply re-
movable thread locker to the two studs sup-
plied. Screw the studs into the underside of the
GPS receiver (part A).
2. Using the gasket (part B) as a template, posi-
tion it at the selected mounting location upside
down with the arrow facing forward. Mark the
position for the two mounting holes and the
center hole for the cable.
3. Using a 3 mm or 1/8" bit, drill the pilot holes. Using a 6 mm or 1/4" bit, drill the two mounting
holes for the studs. Drill the cable hole with a 38 mm or 1-1/2" bit.
Fiberglass -Minimize surface cracking by running the drill in reverse until the gelcoat is pen-
etrated.
4. Pass the instrument connector-end of the cable through the center of the gasket and down
through the center mounting hole in the boat.
5. Plug the cable firmly into the GPS receiver.
6. Orient the gasket with the arrow facing in the same direction as the alignment tab on the GPS
receiver. Push the gasket onto the studs and slide it over the connector.
Note: The gasket fits one way only. A groove in the gasket fits over the alignment tab on the
connector.
7. With the GPS receiver alignment tab pointing forward, push the studs through the mounting
surface. Check to be sure the gasket is tucked under the lip of the unit. From underneath the
mounting surface, slide the flat washer and spring washer onto each stud. Fasten the studs
with the thumb nuts.
Hand-tighten only. Do not over tighten.
8. Coat the circumference of the GPS receiver with silicone sealant so that there is no space be-
tween the GPS receiver and the mounting surface.
GPS receiver (part A)
Aligment tab
Stud (2 pcs.)
GPS connector
Gasket (part B)
Arrow
Mounting surface
Thumb nut (2 pcs.)
Flat washer (2 pcs.)
Spring washer (2 pcs.)