Furuno FA-170, Руководство по установке

Страница: 22 / 76

2. WIRING
2-2
2.2 How to Fabricate the Cables
LAN cable fabrication
1 WHT/ORG
2 ORG
3 WHT/GRN
4 BLU
5 WHT/BLE
6 GRN
7 WHT/BRN
8 BRN WHT/ORG 1
ORG 2
WHT/GRN 3
BLU 4
WHT/BLE 5
GRN 6
WHT/BRN 7
BRN 8
Expose inner vinyl sheath.
[Straight cable]
Remove the outer sheath by
approx 25 mm. Be careful
not to damage inner shield
and cores.
Fold back the shield, wrap it
onto the outer sheath and
cut it, leaving 9 mm.
1 2
3
25 mm
approx. 9 mm
4
5
6
approx. 9 mm
approx. 11 mm
Drain wire
Fold back drain wire and
cut it, leaving 9 mm.
Straighten and flatten the
cores in order then cut them,
leaving 11 mm. Insert the cable into the modular
plug so that the folded part of
the shield enters the modular
plug. The drain wire must be on
the tab side of the jack.
1 8
Modular plug
Cable jacket
Outer sheath
Inner sheath
Cover the cable jacket with insulated tape (20 mm width)
Approx. 200 mm 80
Shielding
Expose the inner and outer
sheaths as shown to the left.
Cover the cable jacket at the
cut as shown to the left.
Using special crimping tool
MPT5-8AS (PANDUIT CORP.),
crimp the modular plug.
Finally check the plug visually.
7