Furuno DS-50, Руководство оператора

Страница: 16 / 29

10
Setting Distance Run
The distance run indication is backed up with an internal battery when the power is off. To reset or
change the distance run, do the following:
1. Open the lid at the bottom of the display unit and press the [SET] key. The display should look
like the illustration below, with the highest digit of distance run blinking.
2. Press
▲
or
▼
to place the blinking cursor on the digit to change.
3. Press ▲ or ▼ to set.
4. Repeat steps 2 and 3 to change other digits.
Note 1:
Distance run can be reset to zero by entering all zeroes.
Note 2:
To restore previous distance run setting, do not operate arrow keys or [SET] key for more
than 10 seconds. When this is done the distance run indication stops blinking and then the
previous setting is restored. Note that if the ship is moving at this time the distance run indication
will change.
5. Press the [SET] key.
1 2 3 0 0
NM: Before pressing [SET] key
NM: After pressing [SET] key
1 2 3 0 0 0 0
Blinking