Furuno CSH-5LMARK-2, Руководство по установке

Страница: 27 / 86

2-1
2. WIRING
2.1 General Description for Cabling
2.1.1 Processor cable between processor and transceiver units
The processor cable is 15 m, 30 m or 50 m long as specified when ordering. A con-
nector has been fitted for the transceiver unit end. The processor unit end of the cable
should be fabricated at installation, after cutting it to an appropriate length.
2.1.2 TX cable between transceiver and pre-amplifier units
TX cable (19 pair cable)
The length of the TX cable is 5 m, 10 m or 15 m long cable is available. Both ends of
the cable are fabricated at the factory. However, the connector housing is not attached
to the pre-amplifier unit end, so that the cable can easily be run through conduit pipe
if necessary. Insert contact pins of the TX cable to the connector housing at installation
referring to the interconnection diagram. Note that the cover plate should not be fitted
to the connector of the pre-amplifier unit side.
RX cable (RX168 core cable assy)
The RX cable is available in length of 5 m, 10 m or 15 m. The cable is fitted with con-
nectors at both ends so fabrication in the field is not required.