Furuno CSH-5LMARK-2, Руководство по установке

Страница: 14 / 86

1. MOUNTING
1-6
5. Inscribe bow mark on the top part of main shaft. Install fastening band, flat wash-
ers, gasket and cable gland as shown below.
Installing fastening band and cable gland
6. Install grease cotton on the main body as below.
a) Install grease cotton on the main body as below.
b) Mark on the cotton as below.
c) Remove the cotton from the shaft, and then cut it at the position of the mark.
Discard the ends.
d) Wind the grease cotton as shown below.
e) Push the grease cotton into the main body flange.
f) Tighten the grease cotton retainer.
Installing grease cotton
WARNING WARNING
Inscribe line,
referring to bow
mark on transducer.
Fastening band
Gasket
Cable gland
Flat washer
Tighten cable gland
securely for a gap
of 3 mm.
Bow mark
Shaft
retainer
When assembling the hull unit, fasten
the fastening band with the torque of
6 to 8 N•m.
If torque is less than the above, water
leakage may occur because the shaft
may loosen and fall.
Bow mark
Cable
gland
Fastening band
Flat washer
Position joints of cotton
120° apart and push them
into main body flange.
Tighten grease
cotton retainer
for a gap of 7
to 9 mm.