Furuno CH-500, Руководство по установке

Страница: 64 / 129

3. CHECKING AND INITIAL SETTINGS
3-6
3.5 Setting for Synchronizing Transmission with
other Equipment (External KP)
To synchronize transmission with other echo sounder, do as follows:
1. Press the MENU key to open the menu.
2. [COM1] is selected on the menu bar; press T to move the cursor inside the menu.
3. Press T several times to select [TX Rate].
4. Press X to open the setting window.
5. Press W several times to select [EXT.].
6. Press the MENU key to apply the settings and close the
menu.
3.6 Motion Sensor Offset
The motion sensor is built in the raise/lower control unit. Stabilizer functions use the
measurements of the motion sensor. To perform stabilization correctly, offset the mo-
tion sensor.
• When the raise/lower control unit is not separated from the hull unit:
Adjust [Heading] and [Sensor Correct] in the [COM2] menu as required. [Roll Offset]
and [Pitch Offset] do not require adjustment. If the Hull Unit and Raise/Lower Con-
trol Unit do not have a matching heading, adjust the value for [Heading]. See step 7
of the procedure in section 3.3. If the Hull Unit and Raise/Lower Control Unit do not
have a matching azimuth, adjust the value for [Sensor Correct]. See step 13 of the
procedure in this section.
• When the raise/lower control unit is separated from the hull unit:
Adjust [Roll Offset], [Pitch Offset] and [Sensor Correct].
Note: When you adjust the motion sensor offset value, the vessel should be stable.
Menu
: Select : Change Menu: Apply
COM1 COM2 HOR. VERT ES FUNC Key System
Toggle TX power level.
TX Power
TX Pulselength
TX Rate
Interference
AGC
Auto Filter
Reverberation
Volume
High
Long
1 0
On
0
Wide
Off
0. 0
For CH-600 For CH-500
Menu
: Select : Change Menu: Apply
COM1 COM2 HOR. VERT ES FUNC Key System
Toggle TX power level.
TX Power
TX Pulselength
TX Rate
Interference-LF
Interference-HF
AGC-LF
AGC-HF
Auto Filter-LF
Auto Filter-HF
Reverberation
Volume
High
Long
1 0
On
On
0
0
Wide
Wide
Off
0. 0
TX Rate 1 0
EXT. min max
(EXT, 1
~
10 䠅