Furuno CH-500, Руководство по установке

Страница: 44 / 129

1. MOUNTING
1-34
1.6.7 How to mount the raise/lower control unit separately
(not recommended)
The raise/lower control unit is pre-attached to the hull unit. The motion sensor is built
into the raise/lower control unit. Normally, install the hull unit without removing the
raise/lower control unit, to keep the performance of the motion sensor. If you need to
mount the raise/lower control unit separately from the hull unit, do as follows:
Note: When the raise/lower control unit is mounted separately, it is required to extend
the motor, upper and lower limit switch lines. Use the extension cable (supplied local-
ly) whose diameter is
I
7±0.5 mm.
1. Unfasten the two upper hex. bolts (M6
u
25), which secure the raise/lower control
unit.
2. Loosen the two lower hex. bolts (M6
u
25), then detach the raise/lower control unit.
3. Drill four pilot holes to the mounting location.
Note: Select a mounting location so that the “Reference direction” mark faces the
ship’s bow.
4. Screw two fixing bolts (M6
u
25, supplied locally) into the lower pilot holes. Leave
5 mm of thread visible.
5. Hang the notches of the raise/lower control unit onto the bolts fastened at step 4.
6. Screw two fixing bolts (M6
u
25, supplied locally) into the upper fixing holes.
7. Fasten all bolts tightly to secure the raise/lower control unit in place.
8. Adjust the offset value of the motion sensor, referring to section 3.6.
Note: If the motion sensor offset is not compensated, the beam stabilization fea-
ture does not work properly.
Bow
Disa
ble t
ran
sduce
r
ୖୗ
ື
೵Ṇ
ON
OFF
PO
WE
R
Ref
eren
ce
di
rect
ion
ᇶࠉ‽ࠉ᪉ࠉྥ
raise/lo
we
r fu
nc tion
Disa
ble tran
sduce
r
ୖୗື೵Ṇ
ON
OFF
PO
WE
R
Ref
eren
ce
di
rect
ion
ᇶࠉ‽ࠉ᪉ࠉྥ
raise/lo
we
r fu
nc
tion
Disable transducer
ୖୗື೵Ṇ
ON
OFF
POWER
Reference direction
ᇶࠉ‽ࠉ᪉ࠉྥ
raise/lower function
Hex. bolt
(M6×25,
4 pcs)
The “Reference
direction” mark should
face the ship’s bow.
Raise/lower
control unit