(4) Check
Make sure that the lamps on the equipment are in the following condition after connection.
Lamp on equipment
Status
POWER
Lights green.
SYSTEM
Lights green.
PON LINK
Lights green.
LAN 1(1000 Mbps)*
Lights green. (Blinks during communication.)
LAN 1(100 Mbps)*
Lights green. (Blinks during communication.)
LAN 2**
Lights green. (Blinks during communication.)
* Either LAN 1 (1000 Mbps) or LAN 1 (100 Mbps) lights according to the terminal conditions and
settings when the user’s terminal equipment is connected.
** When user’s terminal equipment is connected
See “TROUBLESHOOTING” below if the above status is not established even after waiting a while.
TROUBLESHOOTING
Check the following if communication is disabled or there is a possibility of equipment failure. Contact
the dealer if the equipment does not recover from the fault or in the event of another malfunction.
Status
Check point
POWER lamp does not go on. ・Check that the power plug is connected properly.
LAN1
or
LAN2 lamp does not go on.
・
Check that the LAN cable is connected properly.
・Check that the LAN cable in use is category 5e or superior.
・Check that the LAN cable in use is not broken or defective.
・Check that user’s terminal equipment is in the automatic negotiation
mode.
EQUIPMENT SPECIFICATIONS
Item
Specification
Remark
Interface
Conforms to 100BASE-TX/10BASE-T Standard.
Conforms
to
1000BASE-T/100BASE-TX/10BASE-T Standard.
1 port each
Power supply
100 VAC (50/60Hz)
Power
consumption
10 W or less
Outside
dimensions
38(W)×158(D)×114(H) mm
Projections
not
included.
Weight
Equipment: 0.4 kg or less
AC adapter: 0.2 kg or less
Installation place
Indoors
-8-
330-B1272-AH01
