Turn right (clockwise) to tighten
Page 5 of 5
#B x 8 pcs
#D x 8 pcs
#E x 8 pcs
#F x 26 pcs
I.
Prepare 4 bolt assemblies by
inserting FIRST the lock
washer (#D) onto the bolt (#B)
and then the flat washer (#E)
onto the SAME bolt (#B), in
that order.
II.
Insert the bolt assemblies
through the pre-drilled holes of
the right and the left side of
the headboard (#1) using the
Allen wrench (#G) but expose
about ½” of the bolts’ threads.
III.
Mount the brackets on the 2
side rails (#3) onto the bolts
(#B). Make sure all the
washers are in the FRONT of
the brackets. Use the Allen
wrench (#G) to further tighten
the bolts to secure the two
parts together.
IV.
Repeat the process above to
assemble the other ends of
the 2 side rails (#3) onto the
footboard (#4).
I.
Prepare a complete bed slat by
connecting two end caps (#F)
onto the ends of the slat (#6).
II.
Align the two end caps (#F) with
the pre-drilled holes on each
side of the side rails (#3) and
press firmly down on both end
caps (#F) to lock with the side
rails (#3).
III.
Repeat the process above to
assemble the remaining bed
slats onto the side rails (#3).
IV.
Make sure the bed is rested on
a flat surface and does not feel
loose or wobbly. If it does,
double check that the
bolts/screws are secured and
properly tightened.
ASSEMBLY IS COMPLETED
Note: The correct position of the bed
slats should be arcing UPWARD
when placing on the rails.
