Furniture of America CM7009Q, Руководство по сборке

Страница: 10 / 10

Page 10 of 10
ASSEMBLY IS COMPLETED
I. Prepare a bed slat using two slats (#11), one center connector
(#F) and two end caps (#G). See diagram below for the correct
sequence in connecting those parts.
II. Align the end caps (#G) with the pre-drilled holes on each side of
the side rails (#2) and press firmly down on both end caps (#G)
to lock with the side rails (#2). Then press firmly down on the
center connector (#F) to lock with the center support rail (#4).
III. Repeat the process above to assemble the remaining bed slats
onto the side rails (#2) and the center support rail (#4).
IV. Insert the 6 assembled drawers into the designated area of the
side rails (#2).
V. Make sure the bed is rested on a flat surface and does not feel
loose or wobbly. If it does, double check that the bolts/screws
are secured and properly tightened.
Note: The correct position of the slats should be
arcing UPWARD when placing on the rails.
#F x 15 pcs
#G x 30 pcs
#2
#4
#12