Furness controls FCO770, Руководство пользователя

Страница: 78 / 101

Page 78 FCO770 Users Guide Issue 1
C
C
o
o
n
n
t
t
r
r
o
o
l
l
I
I
n
n
p
p
u
u
t
t
s
s
This detachable tension clamp terminal block accepts wire sizes from 0.08mm
2
to 1.0mm
2
and requires a small flat bladed screwdriver (2.5mm max.) to insert and remove wires.
COM Common connection for all inputs
0V Internally connected to power connector 0V pin
24V Internally connected to power connector 24V pin
Input Default Use Programmed Function * Input
1 Reset 13
2 Start 14
3 Jig Sensor 15
4 Vent Sensor 16
5 - 17
6 - 18
7 - 19
8 - 20
9 - 21
10 - 22
11 - 23
12 - 24
3 2
COM 1
8 9
5 4
7 6
10 11
12 COM
24V 0V
* Optional
15
14
COM 13
20
21
17
16
19
18
22
23
24 COM
24V 0V
The inputs are user-programmable so the default setting shown
may be changed if required.
* The second connector is not fitted as standard. There is a purchase option for enhanced i/o
that provides an additional 12 inputs and 16 outputs if required.
The opto-coupled inputs can be connected to active high or active low circuits since the
common can be either the positive or negative supply. The 24V DC instrument supply would
typically be used for the input circuits, however any DC supply from 5V to 24V could be
used.
Note that the reset input is fail-safe so that it must be made before instrument can start when
remote control is enabled (I/O Configuration menu). See the input connection method
diagrams in the Interfacing section of this guide.