1.
grip kneck shown below,
o
t
n
i
s
r
o
t
s
a
c
t
r
e
s
n
I
Prior to removing the outter packaging.
2. Turn bed onto castors and remove outer
packaging.
3. Fit the headboard (if purchased):
(i) Take two plastic washers as shown.
(ii) Position plastic washers as shown.
Hand-tighten headboard screws into
the four holes. Use a screwdriver if
necessary but DO NOT over-tighten.
4. Fit mattress retainer bar as shown.
5. Retrieve remote control from under
frame (cable tied onto motor) and clip
onto side of bed.
6.
Position mattress on bed.
7. To adjust bed, plug in remote control
and press buttons as required.
Your bed is now ready for use.
•
For handset instructions on this model
please visit page 6.
•
Should you have any problems please
review the troubleshooting on page 11.
In the interests of safety, we recommend that two people assemble the bed. Keep children
away from large plastic bags and any components that could be accidentally swallowed. If
any components are missing do not attempt to use the bed. Please contact your retailer or
Furmanac on +44 (0)1384 408844.
Assembly instructions 2ft 6in or 3ft beds
3
Assembly instructions for 5ft bed with a
north / south split (linked together)
1.
Assemble both bases as per the previous
page.
2.
Link bases together with link bar
supplied. To do this you will need to;
i) Remove plastic screw covers
ii) Tighten
iii) Repeat at both ends
Here is an inner view showing
the linking bar hole. It is
positioned next to the
headboard fixing holes -
push through from inside
to create guides.
For use in emergencies only.
This allows the bed to return
to flat position.
• Remove plastic from around
the battery
• Plug the battery to the
connecter and put back
back in place.
Battery Back Up
