F E A T U R E S
The PL-PLUSD features an advanced digital voltage
meter, while the PL-PLUSDM and PM-8DM provide a
laboratory grade True RMS digital voltage and current
meter. Both meters are located at the center-front panel
of their respective units.
A 15 amp circuit breaker is mounted on the front panel,
allowing quick, convenient power restoration. Simply
pushing the square center tab into the front bezel will
re-activate the breaker after an excessive current load
has tripped it.
The rear panel contains eight switched AC outlets
to power your equipment, (4 for analog equipment
and 4 with additional filtering for digital – computer
components, see below). These AC outlets are spaced
to accommodate up to four plug-mounted power
supplies (“wall warts”).
Power is delivered to the unit by a heavy duty 14 AWG
AC cord, 10 feet (2.4 m) in length for extra reach and
durability on stages and other high-traffic areas.
O P E R A T I O N
Retractable Rack Lights and Dimmer Control: The
PL-PLUSD and PL-PLUSDM utilize a dimmer control
for the two retractable front panel light tubes. The
dimmer knob controls the brightness of both light
fixtures. Turn it clockwise to increase brightness;
turn it counterclockwise to decrease brightness.
Light Tubes and Bulb Replacement: The PL-PLUSD
and PL-PLUSDM feature the familiar slide-out rack
lights pioneered by Furman. These units’ lamps come
supplied with five-watt night light bulbs. Replacements
are available at most hardware stores, and may be
purchased from Furman Sound service as well.
B U L B R E P L A C E M E N T
Bulbs are easily replaced without removing the unit
from the rack.
Here’s How: First, pull the light tube(s) all the way out.
Unscrew the cap on the end of each tube to get access
to the bulb. (Be careful not to push the tubes in after
you have removed the caps.) To unscrew the bulb,
place your index finger across the hole on the
underside of the tube and in contact with the bulb. Use
the ball of your finger to rotate the bulb out of its socket.
Then remove the bulb from the front of the light tube.
Put a new bulb in the tube, rotate it with your finger
from the hole in the bottom of the tube and replace
the light tube cap(s).
NOTE: The caps and light tubes become quite warm to
the touch in normal operation. To avoid burning your
fingers, allow the cap to cool completely before
unscrewing it. If you find that the heat from the tubes is
excessive, try reducing the dimmer knob setting. As an
alternative, you may substitute four-watt bulbs or even
colored Christmas tree bulbs.
The Tape Trick: In cases where the bulb is still warm,
or too tight to unfasten with your fingers, a piece of duct
or gaffers tape about 2 inches square can aid in the
bulb removal. Simply pinch about a quarter inch of the
center portion of tape together, and place the remaining
portion of the adhesive backing on the exposed portion
4
Analog Component Plugs
Digital Component Plugs
Содержание PL-PLUS
Страница 1: ...Metered Six Series Owner s Manual ...
