FunkTronic Major 6a, Руководство пользователя

Страница: 12 / 49

m6a-eng (18.12.2009)
- 12 -
Kompetent für Elektroniksysteme
m6a-eng (18.12.2009)
- 13 -
Kompetent für Elektroniksysteme
Calling by collective call /single tone call
It is possible to preselect 9 collective call frequencies (0..8) per channel . The frequency codes of
these single tones are calculated according to this formula
1.008.000
X = ------------------
F
[Hz]
and are coded in the UGA(1..4)-registers 000...008 as four digit hex-numbers. Please read the
sections P rogramming mode UGA and Attachment, Conversion table (...) .
Example: collective call 1 (channel 2) has the frequency 2135 Hz , then this results in:
1.008.000
X = ------------------ = 472,13 ==> hex-value = $01D8
2135
therefore UGA(2)-reg. 001 = 01D8.
The corresponding collective call signal (single tone) of the activated channel is transmitted by
pressing a collective call button which has been programmed accordingly.
The number and the duration of the collective call signal 0...8 which is to be transmitted is defined
when programming the button.
Ex factory there is no button programmed for collective call .
Status input
By pressing a status input button programmed for this purpose you get to the status input of
the activated channels. Also see section Transmit call with status . Now you can enter a status
with up to three digits by using the numerical keys 0...9 or you can use the button * to delete a
previously entered status. The input is complete when no prompt flashes anymore. After that the
display returns to the standard display.
Ex factory there is no button programmed for status input.
Return call
If you keep the call button pressed down for a moment the ID (received call) which is currently
shown on the display is transmitted as a call.
Also see section Identification memory.
The return call channel can be adjusted in register 001/5.