393313 • 08/03/20
Functional Devices, Inc.
101 Commerce Drive
Sharpsville, IN 46068
Toll Free:
(800) 888-5538
Office:
(765) 883-5538
Fax:
(765) 883-7505
Email:
Website:
www.functionaldevices.com
3
Included Parts List:
Sensor (1)
Base mounting ring (1)
Wall Anchors (3)
Spring mounting clip (2)
PIR detection Mask (1)
7/8” Wall anchor screw (3)
Tools required for install:
Slotted/Phillips Screwdriver
Wire Stripper
Pencil
Wire Cutters
Hole Saw
WARNINGS AND CAUTIONS:
INSTALLATION INSTRUCTIONS
FCC COMPLIANCE STATEMENT:
This device complies with part 15 and part 18 of the FCC rules. Operation is subject to the following two conditions: (1) This device must not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING:
TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER
at circuit breaker or fuse and test that power is
before wiring!
power at
circuit breaker
1
Prepare and connect wires
1/2"
(1.3 cm)
Strip wire
(measure bare wire here)
Cut
(if necessary)
Insert wires into correct terminal blocks and tighten.
Be sure to double check correct wiring connections!
2
N
O
R
M
A
LL
Y
C
LO
S
E
D
N
O
R
M
A
LL
Y
O
P
E
N
C
O
M
M
O
N
N
O
R
M
A
LL
Y
O
P
E
N
+ _
C
O
N
T
R
O
L
C
O
M
M
O
N
N
O
R
M
A
LL
Y
C
LO
S
E
D
24 Vdc
Masking is not required in a corner mounting application.
Select mounting location
Use the included PIR Mask
when sensor location may
cause false ON’s due to
(For best results mount at least 6 feet away from air vents)
3
Wiring to power pack
4
Blu
N/C
Yel
C
Org
N/O
Blk
120-277 Vac
Red
Neutral or Other Phase
Wht/Red 24Vdc (+)
Wht/Blu Control Signal
Wht/Blk 24Vdc (-)
Neutral or
Other Phase
120-277 Vac
24Vdc(-)
CONTROL
24Vdc(+)
Normally Open
Common
Normally Closed
Normally Open
Common
Normally Closed
Low voltage
auxiliary relays
To be installed and/or used in accordance with appropriate
electrical codes and regulations.
If you are unsure about any part of these instructions,
consult a qualified electrician.
Sensors must be mounted on a vibration free surface.
All sensors must be mounted at least 6 feet away from air vents.
Do not mount sensors closer than 10 feet from each other.
Do not touch the surface of the PIR lens. Clean outer surface only.
