5-3
A8CF0EA
The following adjustment normally are not attempted in
the field. Only when replacing the LCD Panel then adjust
as a preparation.
3. White Balance Adjustment
Purpose:
To mix red, green and blue beams correctly
for pure white.
Symptom of Misadjustment:
White becomes bluish
or reddish.
1. Operate the unit for more than 20 minutes.
2. Input the White Raster(70%=70IRE, 25%=25IRE).
3. Set the color analyzer to the CHROMA mode and
bring the optical receptor to the center on the
LCD-Panel surface after zero point calibration as
shown above.
Note:
The optical receptor must be set
perpendicularly to the LCD Panel surface.
4. Enter the Service mode. Press [
-] button on the
service remote control unit and select “C/D” mode.
5.
[CUTOFF]
Press [3] button to select “COB” for Blue Cutoff
adjustment. Press [1] button to select “COR” for
Red Cutoff adjustment.
[DRIVE]
Press [6] button to select “DB” for Blue Drive
adjustment. Press [4] button to select “DR” for Red
Drive adjustment.
6. In each color mode, press [P
/
] buttons to
adjust the values of color.
7. Adjust Cutoff and Drive so that the color
temperature becomes 12000°K (x= 0.272 / y=
0.278 ±0.005).
Test Point Adj. Point
Mode
Input
Screen
[P
/
]
buttons
[VIDEO]
C/D
White Raster
(APL 70%)
or
(APL 25%)
M. EQ.
Spec.
Pattern Generator,
Color analyzer
x= 0.272 ± 0.005
y= 0.278 ± 0.005
Figure
Color Analyzer
It carries out in a darkroom.
L = 3 cm
Perpendicularity
INPUT: WHITE 70%, 25%
25%=25IRE 70%=70IRE
INPUT SIGNAL
All manuals and user guides at all-guides.com
Содержание LT6-M32BB
Страница 33: ...8 6 A8CF0SCP4 Power Supply 4 4 Schematic Diagram All manuals and user guides at all guides com...
Страница 35: ...8 8 Function Schematic Diagram A8CF0SCF All manuals and user guides at all guides com...
Страница 69: ...LT6 M32BB A8CF0EP 2008 05 26 All manuals and user guides at all guides com...
