User’s manual
- 3 -
FUM – 2410/15/20CBP
10. Power switch
To turn on and off AC power to charger.
11. Inlet AC socket wirh fuse holder
B. Battery type selection
AGM/GEL
: Sealed type (VRLA), AGM-GEL, maintenance free, automotive or deep cycle lead acid batteries.
Wet
: Flooded type lead acid batteries (to which water can be added) automotive or deep cycle.
Calcium-Calcium : Sealed type (VRLA) lead acid batteries with calcium content automotive or deep cycle.
B1. Float voltage selection
These fine tuned selections of float voltages enable the best voltage level for maximum battery life. Choose 13.8V when in doubt
or in power supply mode.
Follow the markings on deep cycle batteries of the standby float voltage.
B2. Recommended battery capacity
The following minimum Ah capacities are a generalized suggestion, some batteries can take higher charge current, check with
battery manufacturers for charging batteries with smaller capacity.
Charger model
FUM – 2415CBP, 15A FUM – 2420CBP, 20A FUM – 2425CBP, 25A
Battery capacity
50 Ah ~ 150 Ah
70 Ah ~ 200 Ah
80 Ah ~ 250 Ah
C. Battery charger installation and connection
Observe the warnings & safety precautions before rushing to install and operate the charger.
Check battery condition, fill up cells for wet battery, clean battery poles.
Secure the battery charger in a well ventilated place, make sure the mounting surface is flat and without soft covering material or
loose paper sheet. The air intake is at the bottom and air outlet at the back. Make sure both intake and outlet are not blocked.
Never place charger on top of battery.
Plug in the AC mains and turn on power switch, the charger ON LED and the float LED should be on green indicating charger is
in good order for charging lead acid battery.
Before connecting or disconnecting the charging cable, turn off the power switch and unplug AC cord from the mains. First
connect the red cable to po terminal of charger and the battery po pole. Then connect the black cable to the negative
– terminal and the negative – pole of the battery.
Make sure all the connections are secured and well tighten up, double check on the correct polarity.
Double check again for correct selection of slide switch 1 at charger mode, switch 2 for battery type and switch 3 for float voltage
setting value.
Fig.2
