Products manufactured by Full Gauge Controls, as of May 2005, have a warranty period of 10
(ten) years directly with the factory and 01 (one) year with accredited resellers, starting from the
date of the consigned sale that appears on the tax receipt. After this year with resellers, the
warranty will continue to be in force if the instrument is sent directly to Full Gauge Controls. This
period is valid for the Brazilian market. Other countries have a warranty of 2 (two) years. Products
are warranted in the event of manufacturing failure that makes them unsuitable or inadequate for
their intended applications. The warranty is limited to the maintenance of instruments
manufactured by Full Gauge Controls, disregarding other types of expenses, such as indemnity
due to damage caused to other equipment.
EXCEPTIONS OF THE WARRANTY
The Warranty does not cover shipping and/or insurance costs for shipping products with
indications of defect or malfunction to Technical Support. Also, the following events are not
covered: natural wear of parts, external damage caused by falls, or improper packaging of
products.
LOSS OF WARRANTY
The product will lose the warranty automatically if:
- Failure to follow the instructions for use and assembly contained in the technical description
and the installation procedures contained in Standard NBR5410;
- It is subjected to conditions beyond the limits specified in its technical description;
- It is tampered with or repaired by a person not on Full Gauge's technical team;
- Damage is caused by falling, hitting and/or impact, water infiltration, overload and/or
atmospheric discharge.
WARRANTY USE
In order to receive the warranty, the customer must send the duly packaged product, along
with the corresponding purchase Tax Receipt, to Full Gauge Controls. The shipping charge of the
products is at the customer's expense. It is also necessary to send as much information as
possible regarding the detected defect, thus enabling faster analysis, testing and execution of the
service.
These processes and the eventual maintenance of the product will only be carried out by Full
Gauge Controls Technical Assistance, at the Company's headquarters - Rua Júlio de Castilhos
250 - CEP 92120-030 - Canoas - Rio Grande do Sul – Bra il.
z
Rev. 03
Copyright 2022
All rights reserved
ENVIRONMENTAL INFORMATION
Packaging:
The materials used in the packaging of Full Gauge products are 100% recyclable. Try to
dispose of it through specialized recycling agents.
Product:
Components used in Full Gauge controllers can be recycled and reused if disassembled by
specialized companies.
Disposal:
Do not burn or dispose of controllers that reach the end of their service life. Observe the
legislation in your area regarding the disposal of electronic waste. If you have any
questions, please contact Full Gauge Controls.
According to the chapters of the NBR 5410 standards:
1:
Install surge protectors against supply surges
2:
Sensor and serial communication cables may be together, but not in the same conduit
through which power supply and load actuators pass
3:
Install transient suppressors (RC filter) parallel to loads as a way to extend relay life.
Contactor suppressor wiring diagram
A1
A2
A1 and A2 are the
contactor coil terminals.
Wiring diagram for direct actuator load
suppressors
Load
Supressor
For direct actuator, take into
account the specified maximum
current.
Full Gauge Controls available suppressors for sale
10. IMPORTANT
W
ARRANTY
TERM- FULL
GAUGE CONTROLS
Supressor
