Full Boar FBWDV-40PTU, Инструкция по эксплуатации

Страница: 8 / 11

14 15
Automatic mode (1450W max.)
Connect the power cable on your device
to the automatic power outlet (4) and
connect the suction hose (33) to the
extractor connector on your device
(fig. 24). Check that the connections are
secure and airtight.
You can use the supplied hose adaptor
(19) to connect the suction hose (33) to the
device. To do so, fit it between the suction
hose and the extractor port on the device.
Set the switch (3) on the wet and dry vacuum cleaner to
position AUTO, automatic mode (fig. 25). The moment
you switch on the device, the wet and dry vacuum cleaner
switches on as well. When you switch off the device, the wet
and dry vacuum cleaner switches off as well, after a preset
delay.
Blowing
Connect the suction hose (33) to the blow connector (15) on
the wet and dry vacuum cleaner (fig. 26).
AUTO
OPERATION (cont.) MAINTENANCE
Fig. 24
Fig. 25
Fig. 26
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust as much as
possible.
We recommend that you clean the appliance immediately after you use it.
Cleaning the motor head (12)
Clean the appliance regularly with a damp cloth and some liquid soap. Do not use cleaning
agents or solvents; these may be aggressive to the plastic parts in the appliance.
Cleaning the tank (8)
The container can be cleaned with a damp cloth and some liquid soap or under running
water, depending on the amount of dirt.
Cleaning the filters
Cleaning the pleated filter (24)
Clean the pleated filter (24) regularly by carefully patting it and cleaning it with a fine brush
or hand brush.
Cleaning the foam filter (27)
Clean the foam filter (27) with a little liquid soap under running water and allow it to air-dry.
Maintenance
At regular intervals and before each use, check that the filters in the wet and dry vacuum
cleaner are securely fitted.
IMPORTANT! Before cleaning your wet & dry vac or carrying out any maintenance
procedures, make sure that the motor is off and the vac is disconnected from the
power supply to prevent accidental starting.