5
Congratulations on purchasing a Full Boar Radial Tile
Cutting Machine.
The Full Boar Radial Tile Cutting Machine is designed
for the standard cutting of small and medium-size
tiles (glazed tiles, ceramic tiles or similar) which can be
accommodated by the size of the machine.
It is designed for DIY applications and craft businesses
in particular. It should never be used for the cutting of
wood or metal.
INTRODUCTION
WARNING!
When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire, electric
shock, personal injury and material damage.
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for future reference.
The electric motor has been designed for 230V and 240V only. Always check that the power
supply corresponds to the voltage on the rating plate.
Note:
The supply of 230V and 240V on Full Boar tools are interchangeable for Australia and
New Zealand.
Note:
The power outlet used for the radial tile cutting machine must be protected by a
30mA residual current device or earth leakage circuit breaker.
The supply cored assessed as type Y attached by using AS/NZS 60335.1.
If the supply cord is damaged, it must be replaced by an electrician or a power tool repairer
in order to avoid a hazard.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool. Before use,
inspect the extension lead for signs of damage, wear and ageing. Replace the extension lead
if damaged or defective. When using an extension lead on a reel, always unwind the lead
completely. Use of an extension lead not suitable for the power input of the tool or which is
damaged or defective may result in a risk of fire and electric shock.
