15
Operating the laser (28)
Batteries (supplied) must first be inserted into the laser unit. Refer page
16 “Replacing the battery on the laser”
Stationary operation (Fig. 21)
1. To switch ON: Move the ON/OFF switch (26) to the “I” position.
2. To switch OFF: Move the ON/OFF switch (26) to the “0” position.
3. The laser line is projected onto the material you wish to
process, providing an exact guide for the cut (Fig. 22).
4. You can additionally adjust the laser with the laser
adjustment screw (27).
To do so, undo the screw (27) by a few turns. The laser (28) can now
be moved and adjusted vertically and horizontally on the adapter
(Fig. 23). Tighten screw (27) again when you are satisfied with the
adjustment.
Use as a laser level unit
1. Remove the laser adjustment screw (27). The laser (28)
can now be taken off the adapter and used as an external
laser level unit (Fig. 24).
2. The laser (28) is equipped with two spirit levels (29) and
can therefore be adjusted both horizontally and vertically
(Fig. 24). The base plate of the laser is magnetic, enabling
it to be secured on suitable surfaces.
Fig. 21
Fig. 23
Fig. 22
Fig. 24
OPERATION (cont.)
