Full Boar FBT-0700, Инструкция по эксплуатации

Страница: 8 / 16

8
SET-UP & PREPARATION
WARNING! Ensure the tool is turned off and disconnected from the power supply before
performing any of the following operations.
Using the Depth Rod
The Full Boar FBT-0700 comes with a depth rod that allows you
to drill to a predetermined depth.
1.
Loosen the depth rod securing nut then insert the depth
rod (Fig. 1).
2.
Adjust the depth rod so the drill bit extends beyond the end
of the depth rod to the required drilling depth (Fig. 2).
3.
Tighten the depth rod securing nut to lock the depth rod
into place.
4. Drill the hole until the end of the depth rod touches the
workpiece.
Fitting SDS Max Accessories
1.
Prior to insertion into the chuck, remove any dust and
debris from the SDS Max accessory, then apply some
lubricant to the end of the accessory.
2. Pull and hold the locking sleeve back. Insert the SDS Max
accessory (Fig. 3).
3. Rotate the accessory and continue to insert as far as possible
into the chuck. Release the locking sleeve
4. Check the SDS Max accessory is properly secured in the
chuck by pulling on the accessory. Note: It should have
approx. 10-20mm of movement. This is normal. (Fig. 1).
5. To remove the SDS Max accessory, pull back the locking sleeve and then pull the
accessory out of the chuck.
Fitting the Dust Cover
The dust cover catches dust and debris while using the drill in an upright or overhead
position, helping to avoid dust entering the air vents.
1.
Slide the dust cover over the accessory to be fitted (Fig. 4).
Add lubrication to the end of accessory before inserting into
the SDS Max chuck.
2. Pull back the accessory locking sleeve and insert the
accessory. Release the locking sleeve.
3. Press the dust cover into the end of the locking sleeve.
Required Drilling
Depth
Fig. 1
Fig. 2
Fig. 3
Fig. 4