10
KNOW YOUR PRODUCT
ASSEMBLY (cont).
Circlip
Base Frame
Base Frame
3.
Slide the axle through the hole in the base
frame (9) and out the other side
(fig. 3).
Note:
The circlip on the axle (16) will prevent
the wheel (12) touching the base frame
(9).
4.
Place the second wheel (12) on the
protruding end of the axle (16) and secure
in place with the wheel washer and nut.
Tighten the nut.
.
Note:
By tightening the wing bolt on the axle
frame (fig. 4) the axle (16) will be held in
position and allow the wheel nuts to be
tightened fully.
5.
Check and maintain tyre pressure at
20 psi.
Fig. 3
Fig. 4
Transport Handle
Parts required: Transport handle (7) and M10 Handle assembly fasteners x 2 (21)
1.
Place the transport handle (7) on the base frame (9). Align the holes in the handle (7) and
the base frame (9). From the handle assembly fasteners (21), insert each bolt with washer
from the top. Secure in place with nut (fig. 5,6).
Fig. 6
Fig. 5
