10
OPERATION
Fitting / Removing diamond grinding disc (fig. 7)
Inspect the diamond grinding disc (15) before fitment to ensure it is not cracked or
deformed. The diamond grinding disc is suitable for grinding tasks only. Only use
grinding discs with a diameter of 180mm, bore 22.23mm, height 30mm.
1.
Fit the inner flange (13) on the
spindle. The flange should not
turn on the spindle when
properly attached.
2.
Lay the diamond grinding
disc (15) on the inner flange (13)
so that it lies flat along the
flange.
3.
The two sides of the flange
nut (12) are different. Screw the
flange nut (12) onto the spindle
so that the flat surface of the
flange nut (12) is in contact with
the diamond grinding disc (15).
4.
Depress the spindle lock button (2) and turn the flange nut (12) by hand until
you feel the spindle lock engage.
5.
Use pin spanner (10), turning clockwise to firmly tighten the flange nut (12).
6.
To remove disc, depress the spindle lock button (2) to hold the diamond
grinding disc (15) steady, then turn the flange nut (12) ant-clockwise with the
pin spanner (10)
WARNING!
Press in the spindle lock button (2) only when the spindle is
stationary.
Spindle lock button (2) (fig. 6)
The spindle lock button is provided to prevent the
spindle from rotating when installing or removing a
disc (15). Operate the spindle lock button only when
the tool is turned off, the tool is unplugged, and the
disc has come to a complete stop.
Fig. 6
Spindle
Fig. 7
13
12
10
15
