15
OPERATION (cont.)
3.
Connect the charger to a mains power socket. All the LEDs will flash briefly.
4.
Press the Battery select button (4) to select
the battery types or winter mode (fig. 5). The
battery will be charged using the program
selected.
Note:
The LED corresponding to the battery
type or winter mode (11,12, or 13) illuminates.
5.
Press the Ampere select button (5) to select
the maximum charging current strength
(fig. 6). The battery will be charged using the
ampere selected.
Note:
The LED corresponding to the charging
current strength (14,15, or 16) illuminates.
Note:
The actual charging current depends on
the charge setting the charger is currently in,
and may be less than the set maximum charging
current.
6.
The battery is fully charged when “
FUL
” appears in the LCD screen (2), the
charging process is completed.
Note:
The charger holds the battery at 95%
–
100% available battery capacity
using pulsed charging. If the battery was discharged and the charger shows this
after just a few minutes, this indicates that the battery capacity is low. The battery
cannot be recharged any further.
5
Seconds
Fig. 5
5
Seconds
Fig. 6
WARNING!
Charging may create dangerous explosive gas and therefore
you should avoid spark formation and naked flames whilst the battery is
charging. There is a risk of explosion! It is essential that you ventilate the
rooms well.
WARNING!
The charging current should be 1/10 to 1/6 of the battery
capacity.
