5
Congratulations on purchasing a Full Boar 12V 15AMP
Battery Charger.
Your Full Boar 12V 15AMP Battery Charger FBCBC-1500
has been designed for charging low maintenance and
maintenance-free 12V lead-acid batteries (wet / Ca/Ca /
EFB) and for lead gel and AGM batteries which are used
in motor vehicles.
Read and understand the Owner’s
Manual before operating the 12V 15AMP Battery
Charger. Failure to do so could result in personal injury or
equipment damage.
INTRODUCTION
ELECTRICAL SAFETY
SAFETY INSTRUCTIONS
WARNING!
When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire, electric
shock, personal injury and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for future reference.
The manufacturer cannot accept any liability for damage or accidents which arise due to a
failure to follow these instructions and the safety information.
The tool has been designed for 230V and 240V only. Always check that the power supply
corresponds to the voltage on the rating plate.
Note:
The supply of 220V and 240V is interchangeable for Australia and New Zealand.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared
cord available through the service organization.
Using an Extension Lead
Always use an approved heavy duty extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing. Replace the
extension lead if damaged or defective. When using an extension lead on a reel, always
unwind the lead completely. Use of an extension lead not suitable for the power input of the
tool or which is damaged or defective may result in a risk of fire and electric shock.
